GRBL USB port control board can external connect nema23 nema34 stepper motor driver

GRBL USB port control board can external connect nema23 nema34 stepper motor driver

$30.59

Category:

Description

GRBL USB port control board can external connect nema23 nema34 stepper motor driver

1 x RYC-GRBL-V3 GRBL LASER/CNC Controller

1 x USB Cable

1x CD(Instructions, wiring diagrams, LASER/CNC software, configuration files, etc.)

This is a GRBL open source code-based , 
can be used for Engraving machine, CNC Engraving Machine etc.
Features:
1.Application:use for DIY Engraving machine or Toy  engraving machine, need external connect stepper motor driver, suitable for users who make large stroke engraving machine.
2.Applicable software: GRBL control, Un Gcode Sender, GRBL controller, or other software that supports GRBL code
3. The maximum pulse frequency of the control board: 30KHZ
4.Communication: USB (USB-CH340).
5.Power supply: voltage: 12V,
6. Applicable to stepper motor driver: as long as the stepper motor driver with direction + pulse signal control can be used.
7.Support stepper motor: Determined by the external connect driver, the stronger of the driver’s capability, the larger motor that can be connected
8.Laser interface: 12V, suitable for 12V
9.Spindle motor interface: the maximum support 400W DC spindle motor.
10.With fan interface and TTL signal output interface (for controlling  TTL module).
11.Limit interface: X Y Z limit interface, can be connected to NPN photoelectric sensor
12.Probe interface: for Z axis tool zero.
13. Can connect emergency stop switch. In an emergency, the MCU can be reset to stop the machine.

Reviews

There are no reviews yet.

Be the first to review “GRBL USB port control board can external connect nema23 nema34 stepper motor driver”

Your email address will not be published. Required fields are marked *